TELESCOPIC HANDLER

Introduction

The aim of the Telescopic Handler Course is to provide candidates with the knowledge and practical skills required to safely operate the Telescopic Handler and successfully sit both the Theory and Practical elements of the CPCS Technical Test. NPORS testing is also available on this category.


Candidates will be trained and/or tested by

fully qualified, experienced instructors.

 The main areas covered during training are:

  • Identify the basic construction, purpose and function of components and the purpose and use of all controls and gauges

  • Identify and comply with manufacturers’ instructions in accordance with the operator’s handbook, other information sources i.e. load charts and applicable legislation

  • Explain all relevant documentation

  • Carry out pre-use and running check

  • Configure the Telescopic-Handler for site and road travel

  • Travel over differing types of terrain, including rough undulating ground (not applicable to Industrial Telescopic) and substantial inclines, both with and without a load

  • Manoeuvre in confined areas using forward and reverse direction, both with and without a load

  • Set the Telescopic Handler in order to lift various loads

  • Lift various loads within the full working range of the Telescopic Handler

  • Ensure load integrity and security

  • Transport loads

  • Place and retrieve loads accurately at various points

  • Place and retrieve loads from vehicle bed or trailer

  • Explain precautions to be taken for overhead services and other hazards

  •  Keep within safe working parameters

  • Place the machine in an out-of-service condition

.

CPCS Technical Tests

  • Theory: 1 hour

  • Practical: 2 hours

Variations

  • up to 9m (A17b)

  • all sizes exc 360 slew (A17c)

  CPCS THEORY QUESTIONS A40 & LIFTING CHART


Fiona@donaldmunro.co.uk for Training or Donald@donaldmunro.co.uk  for Plant Hire

                           Tel: 01863 766271   Fax: 01863 766077

©2017 by Donald Munro.